Summary: The failure modes of bearings include surface contact fatigue, abrasive wear, adhesion wear and corro[Read more]

Summary: JTEKT Corporation (hereinafter JTEKT) released recently ,According to our research , JTET has develop[Read more]

Summary: The two ends of the roller of the bearing are made of cavities to make it be flexible. With the help[Read more]

Summary: It relies on the relative movement of the journal and the bearing, the liquid forms pressure oil and[Read more]

Summary: Introduction to Miniature BearingsMiniature bearings refer to metric series, with an outer diameter o[Read more]

Summary: DefinitionThe integral eccentric bearing is also called eccentric bearing, which is mainly composed o[Read more]

Summary: Definition: a centripetal bearing with an outer diameter flange on a ring (usually an outer ring or a[Read more]

Summary: Angular contact ball bearings are suitable for bearing both radial and axial loads. It can also be us[Read more]

Summary: Needle roller bearing has the advantages of small radial section size, good rigidity and high radial[Read more]

Summary: Most of Cylindrical roller bearings are separable bearings, which are very convenient for installatio[Read more]

Summary: Definition: rolling bearings with sealing rings on one or both sides.Discipline: Mechanical Engineeri[Read more]

Summary: Definition: Rolling bearings with dimensions and tolerances expressed in Inches.Discipline: Mechanica[Read more]

Summary: Definition: rolling bearings without dust caps or sealing rings.Discipline: Mechanical Engineering[Read more]

Summary: Steel ball is the most important component of bearing and the most used rolling body in bearing indus[Read more]

Summary: AbstractMagnetic fluid bearing is a sliding bearing with conductive fluid as lubricant and an externa[Read more]

Summary: Bimetallic bearing is one of bearing with free lubrication system the product is made of bimetallic s[Read more]

Summary: Pressure-feed air bearings that use external air pressure are called hydrostatic bearings.[Read more]

Summary: Bearings working in hydrogen supplied (HS) gas are easy to suffer hydrogen embrittlement and electroc[Read more]

Summary: Also t is called as the fulcrum bearing. A bearing supporting an intermediate shaft designed to incre[Read more]

Summary: The roller bus is not straight line and the middle part is concave. The bearing surface can be increa[Read more]